Name : WIFI module MKS HLKWIFI V1.1 remote control
MKS-HLKWIFI is created by MakerBase(MKS) based on HLK-RM04 module, which is
suitable for open-source 3D printer . Also, MKS-HLKWIFI is used for MKS Base
(updated version 1.2), MKS Gen, MKS Mini, MKS SBase, etc, those are
developed by MakerBase , as well as MKS TFT touch screen .
1. Based on strong and stable HLK-RM04 module.
2. Using on MKS motherboard directly .
3. Work with MKS TFT touch screen.
Notice: Due to undercurrent, MKS HLKWIFI can not work with Ramps1.4.
Please visit our github to download firmware:
1.Connect to Aux-1 of MKS TFT28.
2. Connect to Aux-1 on MKS BASE, MKS MINI, MKS SBASE, MKS GEN.
MKS BASE only supports V1.2 updated version.
Usage on Motherboard
1.Connect WIFI module to AUX-1
2.Search for WIFI hotspot and connect.
1).Search hotspot HI-LINK-XXXX, and connect. Password: 12345678;
2).If you can not find the hotspot , press on button of module for 10 seconds,
then restore factory settings.
3).Attention: under default , the baud rate of HLKWIFI is 115200, which
must be as the same as firmware .
3. Configuration on MKS HLKWIFI
1).After enter HI-LINK-XXXX, connect to IP: //192.168.16.254;
2).Log in : accounts: admin; password : admin.
3).Proceed network configuration and modify the Client you need.
4).Any other help, please refer to HLK-RM04 user manual 1.31.pdf.
Use Printrun to print by remote control
Input WIFI IP : 8080
Use Repetier-Host to print by remote control
Choose TCP / IP connection
Use APP to control the printer
MKS HLKWIFI Works With MKS TFT28 Touch Screen
mks_config. TXT Wifi configuration (MKS TFT28 only supports
V1.1 updated version)
The Wifi mode selection :
1.The Wifi mode selection
Change the value behind the colon of “cfg_wifi_mode” into the Wifi network you need (“1” is AP mode, “0” is client mode) .
2. The wifi configuration of client mode
A. wifi name: change the Wifi name behind the colon of “cfg_wifi_ap_name” into your wireless network.
B. wifi password: change the Wifi password behind the colon of “cfg_wifi_key_code” into your wireless network’s password.
C. Dynamic accessing IP: set the value behind the colon of “cfg_ip_dhcp_flag” into you need (“0” indicates static IP, “1” indicates dynamic IP).
D.IP: change the IP behind the colon “cfg_ip_address” into you need.
E. IP mask: change the IP mask behind the colon of “cfg_ip_mask” into you need.
F. Gateway IP: change the gateway behind the colon of “cfg_ip_gate” into you need.
3.Wifi configuration instruction on AP module
A. Wifi name : change the WIFI name behind “cfg_wifi_ap_name” into the hotspot name you need .
B. WIFI password : change the WIFI password behind “cfg_wifi_key_code” into password of wifi hotspot, and save it .
Connect to the HLKWIFI module :
Check the network : disconnected
Use APP to Control Printer