Description
Product Name: offline printing accessories RAMPS 1.4 motherboard
Feature:
– SPI mode
Support – voltage:4.5 to 5.5V
Up to 50 MB/sec data transfer rate
1 – x Smart Borosilicate glass
Sits directly on a RAMPS.
Also be used with other Microcontrollers
Direct insert TF Card printing.
This product is to optimize the production version of the official SDRAMPS based on the principle and firmware completely consistent.
Direct support for open source 3D printer firmware.
Special note: each batch will do the function test, due to the low production difficulty of welding, manual welding.
Suitable for: ramps1.4 and Ultimaker can be used.
Invoice: control board module *1, independent anti static bag packaging
Technical support and guarantee:
And the official Wiki products are basically the same!
Do the power test before delivery, which can be used to ship.
Reviews
There are no reviews yet.