Name: 3D printer control board V1.1 MKS-Gen2Z
Send 30cm or USB 50cm line
1, MKS-Gen2Z is a special order products based on MKS-Gen, especially suitable for single print head, double Z axis 3D printer
Two, 2 Z axis motor can be connected to the Z motor 1, Z motor 2, other functions and MKS-Gen is the same.
Supporting products, not including, need to purchase another:
4 (5) stepping motor: 42 motor with wire
Limit switch 3: MKS limit switch
Motor drive 4988: 4 or 8825
Display 1: 2004 or 12864
Hot bed 1: MK3
1 sets of hot bed temperature measurement: temperature measurement set
Do not include motor drive, motor drive please purchase.
Power supply, motor driver board will be possible to burn the chip and circuit, please confirm again after power.
1, MKS-Gen is a customer base of R & D staff according to Ramps1.4, Megatronics v2.0 and other open source motherboard, special optimization developed and launched a product, particularly suitable for mass production of 3D printer manufacturers and used as the main control board.
2, take full account of stability, heat dissipation, ease of use issues, through continuous printing reliability test.
3, if there is a need to contact the owner.
4, supporting the line can refer to: 2PIN, 4PIN, 3PIN
2560, the 1 and ramps1.4 set on a board, to solve the problem of Ramps1.4 composite interface, easy to trouble.
2, can replace the motor drive, support 4988 drivers and 8825 drive.
3, the circuit board uses the high quality 4 plate, and has specially made the heat dissipation optimization processing; ramps is the 2 plate.
4, the use of high quality MOSFET tube, better heat dissipation.
5, the use of special power chip, support 12V-24V power input, to solve the problem of Ramps voltage conversion chip heating.
6, can accept the 24V input, the same system power can be reduced to the hot bed current to 1/4, to effectively solve the problem of heat MOS tube heat.
7, the firmware can use the open source firmware Marlin, configuration and ramps1.4 is the same, can directly replace Ramps1.4.
8, can be directly connected to the Ramps1.42004LCD control board and 12864LCD control board.
9, set aside the motor pulse and direction of the output port, easy to plug the big current to meet the large current (such as 2A, 5A) motor drive circuit.
10, reserved for Servos on Ramps1.4, AUX-1, AUX-2 interface, to provide 3 5V output, 3 12V output interface.
System connection diagram:
4988 driver connection:
8825 driver connection: