3D printer NTC resistance 100K

$0.40

sold: 23

Description

Name: 3D printer NTC thermistor 100K

We have many Ramp1.4 Marlin firmware, the firmware to run correctly, first go to the configuration parameters in the Configuration.h file.
In addition to the motherboard configuration:
#ifndef MOTHERBOARD
#define MOTHERBOARD 33
#endif
Many beginners often forget the configuration parameters of thermistor, not normally result in measured temperature thermistor configuration parameters are as follows:
#define TEMP_SENSOR_0 / / 3 to set to 3, this is the first printing head
#define TEMP_SENSOR_1 0 / / this is a second printing head thermistor configuration, if not set to 0, if set to 3
#define TEMP_SENSOR_2 0 / / this is a third printing head thermistor configuration, if not set to 0, if set to 3
#define TEMP_SENSOR_BED / / 3 heating bed.

Reviews

There are no reviews yet.

Be the first to review “3D printer NTC resistance 100K”